|Minimum Order Quantity||1 Piece|
|Country of Origin||Made in India|
|Dimesnion||63 x 81 x 76 cm|
STANDARD EQUIPMENT & ACCESSORIES
This is an ultrasonic drilling machine for Beads. A table mounted ultra-sonic vibrator and a current and vibration controller is provided with the machine. Table, Coolant container and emery trays are part of the standard equipment.
Its a fairly easy machine to operate. The process of drilling is through ultra-sonic vibrations with the help of emery powders. The machine is switched on and the current intake is set to the desired levels. The drilling wire soldered to the drilling tool begins to vibrate. The emery powder mixed with water as coolant is made to pass over the drilling wire through the specially provided tray. The stone (normally held with the help of two fingers and thumb) is brought in contact with the drilling where at the point of desired hole and is slightly pushed upward. The drilling wire, helped by ultrasonic vibrations and emery powder starts making the drill. The stone is slowly pushed upward until the hole is through or the desired depth is achieved.
With special drilling tools, one can drill up to 10 mm dia. We have a heavier model for bigger and deeper holes MODEL no. AEW-BDM(H)
Drilling Tools, Drilling Wire, Wire Soldering Equipment and Emery Powders are supplied on request.